Knowledgebase

Setup PPTP-Protocol on TP-Link Router

Important Note:

  • Before you configure “PPTP” protocol on your router you need to make sure that you are able to connect VPN on your PC via PPTP protocol.
  • Moreover, the router you are about to configure PPTP protocol must have “Internet Access“.
  • The router in question is a separate router, not the one provided by your “Internet Service Provider(ISP)“.
  • Refer to the following diagram and make sure the configuration is identical.


1. Now access the router’s GUI by typing “192.168.0.1” in your web browser and press enter.
2. Enter the username as “admin” and password as “admin”.
3. From the top left hand corner select “Network” then select “WAN”.

 

 

4. From the “WAN connection type” drop down menu select “PPTP“.

 

 

5. Enter the “OneVPN username” and “Password”.

 

6. Select “Dyamic IP” and below it enter the “server address“. Get the complete list of server from here.

7. Scroll down and select “Save“.

 

 

8. Now Select “Connect” and you are done.

 
  • Did you find this article helpful


Your comment have been successfully submitted.